Procedures:
1. We need a cylindrical part which has three horizontal bulges like the above tim
grooves on each side.
2. Cut middle of the part to make "C" shape.
3. Trim the part along the black line.
4. The trall shape part does not have any grooves. It has a plain lape shape
5. The trimming has been finished. Then cut long the red line on the photo above.
6. Make sure the right side is flat. If it is not flat, please trim Il again.
Do- -oordrocor
Then the two
We used a cylindron patch
bar three horisontal bruges like
the above. This prooves on each
side,
Cot middle of te part to me
"C" shape
GO
The trail shape part doos not
Save any pooves. It has
plein tape sbmpe.
The trimite in the
The long
the
Mere om at
ili, bless plsss need lng po papasa na po sa susunod sa na lng po may makakita​