What's More
Directions: Arrange the following steps chronologically. Write A for the first step, B
for second and so on. Write your answer before the number.
Hot-iron Transfer
1. Lift the iron then move it to
another area of the design.
2. Place the design on the fabric,
then pin at the corners.
3. Remove excess paper around
the design.
4. Set the flat iron at low setting
before pressing it over an area of the
design for a few seconds.
Tracing Method
1. Go over the lines of the design
using a tracing wheel, a pencil or any
sharp or pointed instrument to trace
the design.
2. Insert the carbon paper or
dressmaker's carbon, carbon side
down, between the design and fabric.
3. Place your design right side up
on your fabric then pin up the
STAMPING
1. Dip the ball of cloth in bluing mixture. Rub the ball of cloth over the
design in one stoke or direction only.
2. Form the soft absorbent cloth into ball.
3. Lay the perforated pattern smooth side up on the part of the fabric where
the design is to be placed.
4. Lift one corner of the pattern carefully to check if the design had been
correctly transferred.
5. Pin the corners of the design.​